Defining Vlan Lag Settings - Dell PowerConnect 3324 User Manual

Assigning Ports to VLAN Groups Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning ports to VLAN
groups as displayed in the VLAN Port Settings page.
CLI Command
interface ethernet
interface
switchport mode {access |
trunk | general}
switchport general pvid
vlan-id
switchport general allowed
vlan add vlan-list
[tagged | untagged]
switchport general allowed
vlan remove vlan-list
switchport general ingress-
filtering disable
The following is an example of the CLI commands:
Console (config)# interface range ethernet 1/e18 - e20
Console (config-if)# switchport mode access
Console (config-if)# switchport general pvid 234
Console (config-if)# switchport general allowed vlan add 1,2,5,6
tagged
Console (config-if)# switchport general ingress-filtering disable

Defining VLAN LAG Settings

The VLAN LAG Settings page provides parameters for managing LAGs that are part of a
VLAN. VLANs are composed of individual ports or LAGs. Untagged packets entering the
switch on a LAG are tagged as specified by the LAG's PVID. To open the VLAN LAG
Settings page:
• Click Switch > VLAN > LAG Settings in the Tree View. The VLAN LAG Settings
page opens.
264 Configuring Switch Infor m ation
Description
Enters the interface configuration mode
to configure an ethernet type interface.
Configures a port VLAN membership
mode.
Configure the Port VLAN ID (PVID)
when the interface is in general mode.
Adds VLANs to a general port.
Removes VLANs from a general port.
Disables port ingress filtering.