Select Unit 2 using the Stack ID button within 15 seconds.
4
Repeat steps 3 and 4 for all stacking members.
5
NOTE: Stack the units according to their Unit ID. For example, the Master Unit is stacked
first, with Unit 2 directly below the Master Unit.
Expanding the Stack
This section contains instructions for adding stacking members. To expand a stack:
NOTE: The Stack Unit ID must be selected within 15 seconds.
Ensure that the stack is operating correctly.
1
Connect the lower Stacking connector to the additional stacking Member unit.
2
Plug in new stacking unit. The device begins to boot.
3
Select the unit number using the Stack ID button within 15 seconds.
4
For each new member, open the existing ring and connect the new member's Stacking
5
cable.
For information on replacing stacking members and reassigning Unit IDs, see
Stack
Members".
Rebooting the Device
NOTE: Before rebooting the device, save the device configuration. After the device is reset, all
unsaved configuration changes are lost.
Enter the CLI mode. The following prompt displays:
1
Console > enable
Enter Reload. The following message displays:
2
>reload
This command will restart the whole system and disconnect your
current session. Do you want to continue?
Enter
3
76
C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h
. The device reboots.
Y
"Replacing