Dell PowerEdge M IO Aggregator Command Reference Manual page 134

Use the
show ip interfaces brief
Layer 3 data transmission. In
an IP address has been assigned to it and the interface's status is operationally up.
Figure 10-2. show ip interfaces brief Command Example (Partial)
FTOS#show ip interface brief
Interface
TenGigabitEthernet 1/1
TenGigabitEthernet 1/2
TenGigabitEthernet 1/3
TenGigabitEthernet 1/4
TenGigabitEthernet 1/5
TenGigabitEthernet 1/6
TenGigabitEthernet 1/7
TenGigabitEthernet 1/8
TenGigabitEthernet 1/9
--More--
Use the
show interfaces configured
To determine which physical interfaces are available, use the
This command displays all physical interfaces available on the switch
Figure 10-3. show running-config Command Example (Partial)
FTOS#show running config
Current Configuration ...
! Version E8-3-17-38
! Last configuration change at Tue Jul 24 20:48:55 2012 by default
!
boot system stack-unit 1 primary tftp://10.11.9.21/dv-m1000e-2-b2
boot system stack-unit 1 default system: A:
boot system gateway 10.11.209.62
!
redundancy auto-synchronize full
!
service timestamps log datetime
!
hostname FTOS
!
username root password 7 d7acc8a1dcd4f698 privilege 15
mac-address-table aging-time 300
!
stack-unit 1 provision I/O-Aggregator
!
stack-unit 1 port 33 portmode quad
!
stack-unit 1 port 37 portmode quad
--More--
120 | Interfaces
command in EXEC Privilege mode to view which interfaces are enabled for
Figure 10-2, the TenGigabitEthernet interface 1/5 is in Layer 3 mode because
IP-Address OK Method Status
unassigned NO None
unassigned NO None
unassigned NO None
unassigned NO None
unassigned YES None
unassigned NO None
unassigned NO None
unassigned NO None
unassigned NO None
command in EXEC Privilege mode to view only configured interfaces.
Protocol
up down
up down
up down
up down
up up
up down
up down
up down
up down
command in EXEC mode.
show running-config
(Figure 10-3).