Changing System Logging Settings - Dell PowerEdge M IO Aggregator Command Reference Manual

Changing System Logging Settings

You can change the default settings of the system logging by changing the severity level and the storage
location. The default is to log all messages up to debug level, that is, all system messages. By changing the
severity level in the logging commands, you control the number of system messages logged.
To change the severity level of messages logged to a syslog server, use any or all of the following
commands in CONFIGURATION mode:
Task
Specify the minimum severity level for logging to the
logging buffer.
Specify the minimum severity level for logging to the
console.
Specify the minimum severity level for logging to
terminal lines.
Specifying the minimum severity level for logging to a
syslog server.
Specify the minimum severity level for logging to the
syslog history table.
Task
Specify the size of the logging buffer.
Note: When you decrease the buffer size, FTOS deletes
all messages stored in the buffer. Increasing the buffer
size does not affect messages in the buffer.
Specify the number of messages that FTOS saves to its
logging history table.
To view the logging buffer and configuration, enter the
(Figure 5-1).
To view the logging configuration, enter the
(Figure 5-2).
Command Syntax
logging buffered level
logging console level
logging monitor level
logging trap level
logging history level
Command Syntax
logging buffered size
logging history size size
show logging
show running-config logging
Command Mode
CONFIGURATION
CONFIGURATION
CONFIGURATION
CONFIGURATION
CONFIGURATION
Command Mode
CONFIGURATION
CONFIGURATION
command in EXEC privilege mode
command in EXEC privilege mode
Aggregator Management | 41