Debugging Ufd On An Interface - Dell PowerEdge M IO Aggregator Command Reference Manual

Debugging UFD on an Interface

To enable debug messages for events related to a specified uplink-state group or all groups, enter the
uplink-state-group
Task
Enable UFD debugging on all or a specified
uplink-state group, where:
group-id specifies an uplink-state group. Valid
group-id values are 1 to 16.
To turn off debugging event messages, enter the
command.
Command
debug uplink-state-group [group-id]
no debug uplink-state-group
debug
Command Mode
EXEC PRIVILEGE
[group-id] command.
Uplink Failure Detection (UFD) | 239