Toshiba Strata CIX Programming Manual page 105

FB Name
Trace State
Trace Size
Trace Category
FB01
1. Press to enable Start or Stop trace. Use the number key pad to make your selection.
Hold
2. Press .
Notes
Start indicates the trace was previously started and is currently running.
●
Stop indicates the trace is not running and all trace buffer data was transferred to SmartMedia.
●
FB02
3. Press to enter trace file size. To change the setting, use the number Dial Pad.
Hold
4. Press .
FB03
5. Press to set trace category. To view setting options, press the
Hold
6. Press twice to execute. Wait for the
7. Enter another program number to continue programming or press
mode.
Note When CTX 670 stops logging data, it automatically sends data to the SmartMedia card. A new trace
file is stored on SmartMedia under the
908) before removing the SmartMedia card to ensure complete data transfer.
Strata CIX/CTX Telephone Button Programming 11/04
FB Summary
Enter 1 or 2 to Start or Stop Message
01
Trace. Stopping the trace outputs data to
the SmartMedia card. Wait for the
prompt on the LCD before proceeding.
Before removing the SmartMedia card run
Program 908. See ìFormat/Unmount
SmartMediaî on page
02 Set the trace data size. Toshiba
recommends leaving this parameter at the
default setting which provides
approximately 15 minutes of trace data.
03
Trace data type to be stored.
1:Start
2:Stop
PROG=
1-105.
1~256 (in bytes)
1 unit = 16 bytes.
default = 2
1:Call Processing
2:Maint and Admin
3:Both of the above
= prompt to display before proceeding.
PROG
# # Hold
Evnttrace
directory. Run the Unmount command (Program
Telephone Button Programming
900 Series Programs
Value LCD Prompt
1:START
2:STOP
SIZE=
1.CP
2.M&A
3.CP+M&A (default)
Scroll Page
or button.
again to exit programming
1-101