Panasonic EASA-PHONE KX-T123210 Installation Manual page 109

\
I
Service Class Selections
I
\
-
1.
-
2.
Allowed
Denied
-
3.
all calls
atoll calls
l
local calls (charged)
l
local calls
l
selected area codes
l
local calls (charged)
l
local calls
:E,:I:"' ""' "'
5.
l
selected exchange
codes (charged)
l
local calls
6.
l
local calls
7.
many calls other than
specific exchange
codes programmed
ointernational calls
I
l
international calls
l
any calls other than
specific area code
programmed
l
international calls
atoll calls
l
international calls
l
toil calls
l
any calls other than
specific exchange codes
(charged) programmed
l
international calls
atoll calls
l
local calls (charged)
l
international calls
atoll calls
l
local calls (charged)
l
selected exchange codes
For
service
class 3, up to 20 area codes can be
selected for use in toll dialing. See " Area Code
Entry for Class 3" on page 3-22.
For service class 5, up to 20 exchange code
(charged) can be selected for use in local dialing
(charged). See " Exchange Code Entry for
Class 5" on page 3-23.
For service class 7, up to 20 exchange code
can be selected for no use in local dialing.
See " Exchange Code Entry for Class 7" on
page 3-24.
For an area that uses area code type as that
exchange code, up to 20 exchange codes
can be selected for use in local dialing. See
" Exchange Code Selection" on page 3-21.
Programming
1.
Dial (62).
" Nig Toll Restrct" will be displayed.
2. Press the NEXT button.
" Jack NO ?+ " will be displayed.
3. Press the NEXT button or dial the jack number
(01 through 32 ).
" a01 : Class-l" will be displayed and " 1" will
C_jack number
blink.
4. Press the service class number (1 through 8).
5. Press the MEMORY button.
The LCD will stop blinking.
6. l
0
0
To advance to the next jack number,
press the NEXT button.
To return to the previous jack number,
press the PREV button.
To go to the desired jack number,
press the SELECT button and then dial the
jack number.
7. Repeat steps 4 to 6, to program the assignment
on the other jack numbers.
8. To return to the initial program mode,
press the END button.
Programming Table
See page 7-22.
3
.:
'-.,
:
3-67