Panasonic EASA-PHONE KX-T123210 Installation Manual page 61

,.............................-
until the desired memory code number (01 through 20)
appears
,
I
_ .............................. ..- CDE=
exchange code with 3 digits
Nothing is stored -......-defaul t (all 20 memory codes)
AB= ml[ : memory code 01
[?ll: memory code 20
Description
The exchange code and area code usually differ
for local and non-local calls, but in some
circumstances an area code may be the same as
a local exchange code. These are important
when Type B or Type C is selected with the
" Area Type Selection" (on page 3-l 8)
programming.
After Type B or Type C is selected with the
" Area Type Selection" (on page 3-l 8)
programming, it is therefore necessary to register
these Exchange Codes to enable dialing of these
numbers.
Local call Exchange Codes when Type B is selected
Exchange code
hod-oooo
t
" O" or" 1 "
Local call (charge) Exchange Codes when Type C is
selected
Exchange code
I
I
4lOll-0000
t
" O" or" 1
"
A maximum 20 Exchange Codes can be registered.
3-21
Programming
1.
Dial (13).
" Ext. Local Code" will be displayed.
2. Press the NEXT button.
" Local NO ? + " will be displayed.
3. Dial the memory code number (01 through
20) or press the NEXT button.
Example:
When dialing (01) or pressing the NEXT
button.
l The LCD will show " Local 01: ... " when
nothing is stored in memory code number
" 01 " .
When area code 212 has been stored,
" Local 01 : 212" will be displayed.
4. Dial the local code, using 3 digits.
l To erase a wrong entry, press the CLEAR
button.
5. Press the MEMORY button.
l
The memory indicator will be lit.
6. l To advance to the next memory code
number, press the NEXT button.
l To return to the previous memory code
number, press the PREV button.
l To go to the desired memory code
number, press the SELECT button and
then dial the memory code number.
7. Repeat steps 4 to 6.
8. To return to the initial program mode, press
the END button.
Programming Table.
See page 7-5.
1
,: :
::.
.t: