Panasonic EASA-PHONE KX-T123210 Installation Manual page 89

_.....................................
until the desired CO number (01 through 12) appears
,...................................................
until the desired jack number appears
I# : on jack number 01
G : on jack number 32
a : to assign the same on all 32 jacks
until the desired mode appears
..~...~~..default (all 32 jack numbers)
or
IEmber/ other CO number
I
II
1
pcNiEiqhh~m&m
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CD=H : to assign the same on all 32 jack numbers
a: on jack number 01
,..........................,.....................
. . . . . . . . . . . . . .
I
32 : on jack number 32
AB=m : to assign the same on all 12 CO' s
a: on CO 01
cj
12
:onCO12
Description
Through programming, you can select which
extensions may be used for outward dialing by
using the day mode of operation.
Programming
1.
Dial (45).
2.
3.
" Day Out CO" will be displayed.
Press the NEXT button.
" CO NO ' ? +" will be displayed.
Press the NEXT button or dial the CO number
(01 through 12).
7.
l
To advance to the next jack number,
press the @ button.
o To return to the previous jack number,
press the m button.
o
To go to the desired jack number,
press the I#I button and then dial the
jack number.
8. Repeat steps 5 to 7, to program the assignment
of the other jack numbers.
9.
l
To advance to the next CO number, press
the NEXT button.
4.
5.
6.
" CO 01 :Ttnable" will be displayed.
lack number
Repeat pressing the m button until the
desired jack number appears, or press the
cl # button and then dial the jack number.
Press the SELECT button to alternate between
" Enable" and " Disable" to select the desired
mode.
Press the MEMORY button.
The LCD will stop blinking.
~.
%' -
;
,:
'
'.
>
;..
" : : .:
o To return to the previous CO number, press
the PREV button.
o To go to the desired CO number, press the
SELECT button and then dial the CO number.
10.
Repeat steps 4 to 9, to program the
assignment of the other CO numbers.
11.
To return to the initial program mode, press
the END button.
Programming Table
Seepage7-11.
3-47