Panasonic EASA-PHONE KX-T123210 Installation Manual page 87

:......;...........-until the desired CO number (01 through 12) appears
up to 8 outside access codes each with a
maximum of 2,digits
Nothing is stored ............ default (all 12 CO' s)
: to assign the same on all 12 CO' s
Description
If the system, (KX-T123210) is installed behind a
host PBX, the host PBX may require a pause time
to access Central Office Lines. This feature
enables the host PBX to automatically pause via
programming the outward dialing access codes
of the. host PBX.
6. l
0
0
To advance to the next CO number,
press the NEXT button.
To return to the previous CO number,
press the PREV button.
To go to the desired CO number,
press the SELECT button and then dial the
CO number.
Programming
7. Repeat steps 4 to 6 to program each of the
1.
2.
3.
4.
Dial (43).
" Host PBXAccess" wilI be displayed.
CO' s of the KX-T 1: 23210.
8. To return to the
I
nitial program mode, press
Press the NEXT button.
" CO NO ?-+" will be displayed.
the END button.
Press the NEXT button ordial the CO number
Example:
(01 through 12).
l AccessCodes ,82,83,9onCOl
0 The LCD will show ' CO 01 : Not Stored"
when nothing is stored in CO 1.
When the outside access codes 81,82 has
been stored, " CO 01 : 81,82" will be
Programming Table
displayed.
Enter up to 8 outward access codes each
with a maximum of 2 digits, punctuating each
code with the " m" button.
l To erase a wrong entry, press the CLEAR
button.
5. Press the MEMORY button.
Seepage7-10.
3-45