Ath Disconnect Existing Connection - Siemens MC55 Command Set

Hide thumbs Also See for MC55:

Table of Contents

MC55 AT Command Set

ATH Disconnect existing connection

Exec Command

Reference(s)

Command Description

Disconnect existing call from command line by local TE and terminate call.

Parameter Description

OK is issued after circuit 109 (DCD) is turned off, if it was previously on.

terminates every circuit switched call (voice, data or fax), even if it is issued via another interface. This

behavior is in accordance with ITU-T V.25 ter; (07/97, "Hook control": "

progress.").

clears any active PDP context or terminates any existing PPP connection, but only if issued on the same

interface where GPRS is used and if there is no pending network request for PDP context activation. It does

not affect PDP contexts and PPP connections on other interfaces (see also Chapter "

of a network request for PDP context activation").

MC55_ATC_V01.05

Confidential / Released

disconnect from line and terminate call

Page 151 of 469

is terminating any call in

Manual rejection