Siemens MC55 Command Set page 414

MC55 AT Command Set
16.15 AT^SNFS
Parameter Description
(num)(^SNFW)
<audMode>
[1]
2
3
4
5
6
Notes
• The write command can be used during a voice call to switch back and forth between different modes. This
allows the user, for example, to switch handsfree operation on and off.
• Users should be aware that
during a call, the value of
with or
AT^SNFM AT+CMUT
call, then the microphone remains muted until explicitly changed. Exception: In audio mode 1
is fix.
MC55_ATC_V01.05
Confidential / Released
Audio mode 1: Standard mode optimized for the reference handset, that can
be connected to the analog interface 1 (see your "Hardware Interface Descrip-
tion" for information on this handset.) To adjust the volume use the knob of the
reference handset. In audio mode 4, this handset can be used with user
defined parameters.
Note: The default parameters are determined for type approval and are not
adjustable with AT commands.
restores
AT^SNFD <audMode>
Audio mode 2: Customer specific mode for a basic handsfree device (Siemens
Car Kit Portable).
Analog interface 2 is assumed as default.
Audio mode 3: Customer specific mode for a mono-headset.
Analog interface 2 is assumed as default.
Audio mode 4: Customer specific mode for a user handset.
Analog interface 1 is assumed as default.
Audio mode 5: Customer specific mode.
Analog interface 1 is assumed as default.
Audio mode 6: Customer specific mode.
Analog interface 2 is assumed as default.
is a global setting. This means, when another audio mode is selected
<outStep>
does not change. This is also true for mute operation which can be set
<outStep>
: If the microphone is muted and the user selects another audio mode during the
Page 414 of 469
s
1.
m
obile
=4
<outStep>
2/10/04