Ats10 Set Disconnect Delay After Indicating The Absence Of Data Carrier - Siemens MC55 Command Set

MC55 AT Command Set
7.15 ATS10
7.15 ATS10 Set disconnect delay after indicating the absence of data
carrier
Syntax
Read Command
ATS10?
Response(s)
<n>
OK
Write Command
ATS10=<n>
Response(s)
OK
PIN ASC0 ASC1 MUX1
! % !
Reference(s)
V.25ter
Command Description
This parameter setting determines the amount of time, that the TA remains connected in absence of a data car-
rier. If the data carrier is detected before disconnect, the TA remains connected.
Parameter Description
(num)(&W)(&V)
<n>
number of tenths of seconds of delay
(&F)
001...2 ...255
MC55_ATC_V01.05
Confidential / Released
MUX2 MUX3
% ! !
Page 158 of 469
s
m
obile
2/10/04