Controlling Cameras; Performing Pan, Tilt, And Zoom Operations - Sony IPELA NSR-500 Series User Manual

Notes
• In the monitor frame is set as the hotspot, the images of
the corresponding camera are displayed in cases such as
the following.
– When the monitor frame is selected.
– When there was a sensor input.
– When a motion detection alarm occurred.
• When a sensor input, or motion detection, alarm occurs,
and the monitor frame is displaying images from the
camera to which the alarm is being input or images from
the camera on which the alarm is occurring, a red frame
will appear around the monitor frame.
Switching a Monitor Frame to 1×1 View
Double-click on a monitor frame to switch the layout of
that monitor frame to 1×1 view.
Double-click the monitor frame again to restore the
original layout.
Note
If you switch to another layout or the layout is switched by
an action or layout tour after switching to 1×1 view,
double-clicking will not restore the original layout.
104

Controlling Cameras

Controlling Cameras
When monitoring with a camera equipped with pan and tilt
functions, you can monitor images from the camera while
performing pan, tilt, and zoom operations on the Camera
Control pane on the right side of the screen or with the
mouse.
For details on the operating procedure of the Camera
Control pane, refer to "Functions and Operating
Procedure of Main Screen" (page 98).
Note
Camera control is only enabled for network compatible
cameras.
Performing Pan, Tilt, and Zoom
Operations
Using Camera Control Pane to Control
Camera
1
Select any monitor frame, and display the images of
the camera you want to control.
2
Use the Camera Control pane to control the camera.