Rear - Sony IPELA NSR-500 Series User Manual

M Power switch
Press this to turn on the unit.
If you press the power switch during operation, the
POWER LED blinks green for up to 3 seconds.
Pressing the power switch again during this time turns
off the unit.
If 3 seconds elapse without the power switch being
pressed while the POWER LED is blinking, the unit
does not turn off and operation continues.

Rear

NSR-500
1
qs
When NSBK-DH05 (optional) is mounted
7 qd
A Fan
Caution
Take care not to obstruct the fan grille. If the grille is
obstructed, heat may build up in the unit, leading to
damage and/or fire.
B AUDIO OUT (line output) connector (stereo)
Use these connectors to output audio to a peripheral
audio device.
C AUDIO IN (microphone input) connector (used for
future expansion)
Use this connector to input audio from a peripheral
audio device, such as a microphone.
Plug-In Power microphones are supported.
qa 0
Caution
Pressing and holding down the power switch
(approximately 5 seconds) turns off the unit forcefully.
N POWER LED
Lights green when the unit is turned on.
If you press the power switch during operation, the
POWER LED blinks green for up to 3 seconds.
2 34 5
9 8 7 6
When NSBK-EB05 (optional) is mounted
7 qf
D RS-232C 1 (UPS) connector
Use this connector to connect the control line of the
uninterruptible power supply (UPS).
E RS-232C 2 connector
Use this connector to connect analog cameras via the
analog camera input cable.
This connector cannot be used at the same time as the
I RS-422/485 connector.
For pin assignment details and wiring diagrams for
sensor inputs, refer to the Installation Manual
(separate document).
F
LAN connectors (1 and 2)
Use these connectors to connect 10Base-T, 100Base-
TX, or 1000Base-T network cables.
LAN1: Network cameras
1)
Features and Functions
9