Sony IPELA NSR-500 Series User Manual page 15

To use a DHCP to obtain the address setting automatically:
Select [DHCP].
To configure the address setting manually:
1 Click [Static].
2 Enter the following address.
IP Address
Enter the IP address.
Caution
• Before you enter the IP address, make sure there is
no machine that uses the same value on the same
network. Even if a machine that uses the same value
does exist, an error message will not be displayed.
However, be careful because more than one machine
using the same value will result in incorrect
operation.
• Do not set an IP address that is prohibited under the
IP address assignment rules.
Example: 224.0.0.0 to 255.255.255.255
0.0.0.0
127.0.0.1, etc.
Netmask
Enter the subnet mask.
Route Setting
Click this when you need to configure the route to
another network.
Configure the settings as follows on the Route For
Network Device 1 screen that appears.
1 Enter the address, gateway, and netmask of the
other network to which to connect, and click [Add]
to add the network to the list.
For details, contact the administrator of the network
to which you will connect.
2 Click [OK].
Setting Items of Monitor Screen
Select the resolution of the monitor connected to the unit,
and click [OK].
If you select [Auto], the maximum resolution of the
connected monitor will be detected and selected
automatically.
Setting Items of Audio Screen
Select the audio connector you want to use, and click
[OK].
When using audio output from an HDMI monitor, select
[HDMI]. ([HDMI] can only be selected when an optional
NSBK-DH05 is installed.)
Caution
When removing an NSBK-DH05 from the main unit, be
sure to check that AUDIO OUT is in use. If the
NSBK-DH05 is removed from the main unit while
[HDMI] is selected, audio will not be output from AUDIO
OUT until it is reselected. In such cases, reselect [AUDIO
OUT] in the Audio screen.
Setting Items of Disk Screen
Configure iSCSI settings.
Caution
Contact your Sony dealer when using iSCSI.
Changing Initial Settings with the Setup Menu
15