Panasonic EBL128 Planning Instructions page 6

Panasonic Electric Works Nordic AB
MEW01090 Rev: 3
13.1.3 Decision value ________________________________ 82
13.1.4 Alarm algorithms for smoke detectors / Detection levels /
Offsets 82
13.1.5 Alarm algorithm / Alternative alarm algorithm ______ 83
13.1.6 Filtering algorithm ____________________________ 84
13.1.7 Smouldering smoke algorithm ___________________ 86
13.1.8 Performance factor ____________________________ 88
13.2 Analog heat detectors ______________________________ 88
13.2.1 Class A1 algorithm ____________________________ 89
13.2.2 Class A2 S algorithm __________________________ 89
13.2.3 Class B S algorithm ____________________________ 89
13.3 Self verification ___________________________________ 90
13.4 Minimum / Maximum sensor values ___________________ 90
13.5 Two-unit dependence (co-incidence alarm) _____________ 90
13.6 Two-zone dependence (co-incidence alarm) _____________ 91
13.7 Delayed alarm ____________________________________ 92
13.8 Alarm Verification Facility __________________________ 92
13.9 Alert Annunciation ________________________________ 92
13.10 Alarm Acknowledgement Facility (AAF) _____________ 94
13.11 Quiet alarm ____________________________________ 96
13.12 Fire alarm type A and Fire alarm type B ______________ 96
13.12.1 Fire alarm type B ____________________________ 97
13.12.2 Fire alarm type A ___________________________ 97
13.13 Disable zones, alarm points, outputs, etc. _____________ 97
13.13.1 Disable zone _______________________________ 98
13.13.2 Disconnect / Re-connect zone line ______________ 98
13.13.3 Disable zone / address ________________________ 98
13.13.4 Disable control output ________________________ 98
13.13.5 Disable / Re-enable all control, exting. and ventilation
outputs 98
13.13.6 Disable / Re-enable alarm devices ______________ 98
13.13.7 Disable outputs for routing equipment ___________ 98
13.13.8 Disable interlocking output ____________________ 99
13.13.9 Disconnect / Re-connect COM loop _____________ 99
13.14 Test mode _____________________________________ 99
13.15 Test alarm devices _______________________________ 99
13.16 Test of routing equipment ________________________ 100
13.17 Calibration of supervised outputs __________________ 100
13.18 Service signal _________________________________ 100
13.19 Fault signal (fault condition) ______________________ 100
13.20 Alarm texts ___________________________________ 101
13.20.1 Creating the alarm texts via Win128 ____________ 101
13.20.2 Downloading texts to the EPU 1728, AAUs 1735 /
1736 and ext. FBPs 1826 / 1828 ________________________ 103
13.21 Real time clock (RTC) __________________________ 103
13.21.1 Daylight saving time ________________________ 104
EBL128 Planning Instructions V1.1.x
4