Key Function/Multifunction Registration - NEC Xen IPK Features & Specifications Manual

Key Function/Multifunction
Registration
FEATURE
DESCRIPTION
SYSTEM
AVAILABILITY
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Features and Specifications Manual
The system can be registered as either a Key Function (KF) or a
Multifunction (MF) telephone system. This feature is set via a switch on the
CPUI( )-U( ) ETU at the time of installation.
Terminal Type
Not applicable.
Required Components
CPUI( )-U( ) ETU
Not applicable.
General
When the system is set as KF, CO/PBX lines must appear on Multiline
Terminals. Outside calls cannot be made by dialling a Trunk Access
Code from internal dial tone except when specified trunk seizure
is used.
When a system is set as KF, the following CO/PBX calls are
prohibited:
Route Advance key
Trunk Group key
Hot Line/Prime Line with Automatic Trunk Selection
Trunk Group Access Call, Route Advance Access Call
Least Cost Routing (LCR)
Speed Dial with Automatic Trunk Selection
Last Number Redial with Automatic Trunk Selection
When the system is set as multifunction, CO/PBX lines can be
accessed from internal dial tone by dialling a Trunk Access Code.
KF or MF selection is set by a hardware switch on the CPUI( )-U( )
ETU. To change the KF/MF selection after First Initialisation of the
system, First Initialisation must be performed again.
In KF mode, Single Line Telephones can be used for internal calls and
can access an outside line using the specified trunk seizure Access
Code or Prime Line Pickup assignment.
K-1
K1 – 389