For Husqvarna Parts Call 606-678-9623 or 606-561-4983
9
Insert tool no. 506 56 76-01 into the centre of the
engine pulley. Unscrew and remove the socket
head cap screw which holds the pulley and the
engine axle together. Use tool no. 506 89 92-01 as
a holder-on. Remove the pulley from the engine
axle. Use the 506 66 48-01 puller if necessary.
10
Note where the battery's negative cable is
connected. Disconnect it from the engine if
necessary. Remove the engine attachments, two on
each side of the engine, and remove the engine
from the mower.
506 56 76-01
www.mymowerparts.com
Replacing engine
IMPORTANT INFORMATION
When installing the engine, it is important
that the pulley groove (1) is in a position
so the outgoing axle key (2) fits into the
groove (see diagram). Also check that
both spacing collars (3) and the key (2) are
firmly attached on the engine axle. Grease
the engine axle.
1
Lower the engine into place.
Connect the battery's negative cable. Tighten the
engine fixtures (two on each side of the engine)
with a torque of 20-25 Nm / 14-18 lbf. ft.
Reparation instructions
25
English –