Husqvarna Rider 15V2 Workshop Manual page 27

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
2
Position the pulley with tool no. 506 56 76-01 and
tighten it with moment (70-80 Nm/50-56 lbft). Use
tool no. 506 89 92-01 as a holder-on.
3
Place the wires in the wire holder. Make sure that
the hydrostatic transmission wire is at the bottom.
Clamp together the holder and bring it from
underneath through the centre of the belt tensioner
until it hooks over the top edge of the tensioner.
4
Attach the throttle cable to the carburettor and fit
the cable clip without tightening it. Make sure that it
goes into the proper hole, see illustration.
Push the choke control to full choke position. Pull
wire's outer casing as far as possible to the right
and tighten the wire clamp.
26
– English
506 56 76-01
www.mymowerparts.com
5
Hook the throttle wire onto the carburettor and fit
the wire clamp without tightening it. Push the
throttle control to full throttle position. Pull the wire's
outer casing as far as possible to the left and
tighten the wire clamp.
6
Attach the silencer and exhaust pipe and tighten
the holder screws and pipe clamps.
Rider 15V2 does not have Pulse air filter, as shown
in the illustration.