Belt Replacement On Combi 103 - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
IMPORTANT INFORMATION
On a BioClip 90 unit the blades should be
positioned at 90 to each other. Otherwise
the blades can contact each other which
may result in damage to the cutting unit.
5. Check that the blades are positioned at 90 to
each other as illustrated, otherwise the belt
must be adjusted. When the blade bearing is
loose the belt can be guided over to the next
tooth. Tighten the nuts so much that the
bearings rest against the mowing hood, but can
still be moved.
Tension the belt by turning the eccentric
adjuster on the top of the mowing hood. Tighten
the nut. Tighten nuts on the blade bearings.
6. When the belt moves 8 mm (5/16") inwards at a
force of 7 N (1.5 lb) the belt tension is correct.
7. Fit the protective cover over the belt and secure
the parallel strut.

Belt replacement on Combi 103

1. Dismantle the cutting unit.
2. Loosen the front bolt on the parallel strut and
swing back the strut. Swing the height
adjustment strut forwards.
WARNING!
Protect your hands with gloves
when working with the blades.
3. Loosen the two screws holding the protective
cover and lift off.
www.mymowerparts.com
Reparation instructions
57
English –