Husqvarna Rider 15V2 Workshop Manual page 61

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
6
• Mark one end of the shaft. Press out the axle
with a puller.
• Knock out the bearings and remove the spacer.
7
The entire packet can be bought as a complete set
with axle housing, axle, spacer and bearing.
Installation is carried out in the reverse removing
order.
IMPORTANT INFORMATION
When tightening the screws for the blade
shafts the screws on the transmission
side should always be tightened first,
followed by the blade screws.
The friction washer on a BioClip or Combi
103 unit must be replaced when replacing
the shear pin.
Ensure that the axle is fixed in the same direction
as it was removed, if not the keys will not fit into the
key-way.
Tighten the blade bearings to a torque of 20–25 Nm/
14-18 lbft.
60
– English
www.mymowerparts.com
Removal of blades with bearings
New version (Combi 122)
You can recognise this by the fact that the collar on
the bearing housing is located on the underside of
the unit's cover.
WARNING!
When working with the mowing
deck, use protective glasses and
gloves.
1
• Remove the cutting unit's upper cover, see 'Belt
Replacement'.
• Loosen the spring (1) that tensions the V-belt
and pull the belt off.
2
• Loosen the screw that holds the belt pulley (2) a
few turns. Lock the blade with a wooden block or
hold the belt pulley in place, with an oil filter
wrench, for example.