Removal Of Blades With Bearings - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Removal of blades with bearings

Older versions
You can recognise these by the fact that the collar
on the bearing housing is located on the top of the
unit's cover.
WARNING!
When working with the mowing
deck, use protective glasses and
gloves.
1
• Remove the cutting unit's upper cover, see 'Belt
Replacement'.
• Release the spring which tensions the V-belt (1)
and twist off the belt.
• Unscrew the screw which holds the pulley (2)
and detach the pulley, a puller may be needed
for this. Do not lose the key which is found
between the pulley and the axle.
2
Unscrew the screw which holds the blade and
remove the screw, washer and blade.
www.mymowerparts.com
3
Unscrew the four screws which hold the blade
bearing and remove the entire bearing packet from
the mowing deck.
4
Remove the hub using a puller. Do not lose the key
which is found between the pulley and the axle.
5
Remove the sheet metal safety washer.
Reparation instructions
59
English –