Husqvarna Rider 15V2 Workshop Manual page 38

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
3
• Loosen the steering wires (1) and remove the
steering rim.
• Remove the pulley (2). Move the lower part
forwards, the upper part backwards and detach
the pulley.
4
WARNING!
The articulation spring is strongly
tensioned and can cause injury if
it flies off. Wear safety glasses
and gloves when removing/
attaching the spring.
Detach the articulation spring. This spring is heavily
tensioned and should be released using tool 506
89 93-01 before the screw for the rear bracket is
removed.
www.mymowerparts.com
5
Remove the inner circlip (1) from the lower bearing
(see diagram). The rear section is now loose and
can be moved. Then detach the outer circlip (2) and
take the bearing out downwards.
6
• Take the upper bearing out upwards, if it does not
come out easily, it should be knocked out from
below.
• Insert the new bearings and assemble the
articulated steering in the reverse removal order.
• After re-assembly, the wire tension should be
checked (see "Checking and adjusting steering
wires"). Also check that the controls and cables
are properly adjusted, (see 'Checking and
Adjusting the Brake Cable' and 'Checking and
Adjusting the Accelerator').
• Check the setting of the neutral position switch.
Reparation instructions
37
English –