Belt Replacement On Cutting Unit With Side; Or Rear Ejection And Combi 112, 122 - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
4. Tip: Mark the position of the blades on
respective belts with a felt tipped pen.
Loosen the three screws 1/2 - 1 turn. Squeeze
the belts to their maximum slackness and
tighten one of the screws. Change the belt and
tighten as shown in the illustration (decal is on
the cover). Set the blades at 90 angles and
loosen the screw again. The spring provides the
proper tension to the belt. Check the position of
the blades again, adjust as needed by re-setting
the belt. Tighten the three screws to 45 Nm / 32
lbf. ft.
IMPORTANT INFORMATION
On a Combi 103 unit the blades should be
positioned at 90 to each other. Otherwise
the blades can contact each other which
may cause damage to the cutting unit.
5. Fit the protective cover over the belts and
secure the parallel strut.
Belt replacement on the cutting unit with side or
rear ejection, Combi 112 and Combi 122
The blades on these cutting units with 'collision-
proof' blades are driven by a V-belt. Do as follows
to replace the V-belt:
1. Dismantle the cutting unit.
2. Loosen the bolt to the parallel strut and the two
screws on the cover. Lift off the cutting unit
cover.
3. Loosen the spring (4) that tensions the V-belt
and pull the belt off. Attach a new belt in the
reverse order.
58
– English
www.mymowerparts.com