Replacing Articulated Steering Bearing - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions

Replacing articulated steering bearing

1
• Remove the engine according to the earlier
description (see "Removing engine").
• Block up the ride-on mower in front of the articulated
steering.
• Work off the drive belts.
• Release the oil tank for the transmission and move it
to one side to get at the brake wire.
2 Rider 15V2
• Loosen the idler's spring (1).
• Loosen the hydrostatic transmission cable (2)
from the arm (3) and the casing from the fixture
(4).
• Loosen the cable from the neutral position
contact (5).
• Loosen the brake cable from the arm under the
tank and the casing mounting from the rear
frame (6).
36
– English
www.mymowerparts.com
2 Rider Pro 15 and Pro 18
4
2
• Release the tensioning wheel spring (1).
• Remove the locking spring and release the
locking spring on the linkage for throttle controll,
on the underside, and release the wire from the
underside of the axle (2).
• Release the brake wire spring and nuts. Prise the
wire off the brake arm (3).
• Remove the cable from the neutral position switch (4).
Only Rider Pro 18
• Clean, see 'Hydraulic system\Working methods'.
• Loosen the hydraulic hoses from the hydrostatic
transmission.
1
3