Removal Of Swing Axle - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions

Removal of swing axle

1
• Block-up the machine in front of the rear frame.
• Remove the transmission cover.
• Release the oil tank for the transmission and
move it to one side to get at the brake wire.
2 Rider 15V2
• Loosen the idler's spring (1).
• Loosen the hydrostatic transmission cable (2)
from the arm (3) and the casing from the fixture
(4).
• Loosen the cable from the neutral position
contact (5).
• Loosen the brake cable from the arm under the
tank and the casing mounting from the rear
frame (6).
• Remove the circlip and lift off the hydrostatic
transmission's fan (7).
• Remove the rear belt (8).
• Remove the circlip and washer from the
pendulum shaft and pull out the rear belt
backwards.
38
– English
www.mymowerparts.com
2 Rider Pro 15 and Pro 18
5
2
• Clean and loosen the hydraulic hoses on Rider
Pro 18 in accordance with the Hydraulic
System\Working Methods. Illustration, see
'Fitting'.
• Remove the cooling fan, which is held by a
single nut.
• Disconnect the spring from the tensioning roller
(1) and prise off the drive belt.
• Remove the spring clip, prise apart the speed
control ball joint (2) (underneath) and disconnect
the wire from the underside of the shaft.
• Disconnect the lead from the neutral switch (5).
• Remove the spring and nuts from the brake wire
(3) and unhook the wire from the brake arm.
• Remove the circlip and washer from the swing
axle (4) and remove the rear frame.
3
Remove the circlip and washer from the swing
axle's inner holder (1) and pull the swing axle out
backwards. Use a suitable drift or puller if needed.
If the dust protection (2) is damaged, this should be
replaced by a new one.
4
1
3