Automatic Inet Reconfiguration; Inet Configuration - HP 5890 Series II Plus Reference Manual

Signal Output

INET configuration

Automatic INET reconfiguration

In the following circumstances, INET automatically reconfigures under
direction of the controller:
Recovery from a power failure.
Recovery from any particular device on the loop being switched off,
then on again.
Recovery from a disconnected (then reconnected) loop cable.
Consult appropriate manuals for the controller in the event of problems
arising from any of these circumstances.
INET configuration
The CONFIGURE NETWORK function provides four features: verifying
the INET address for the HP 5890 (as determined through automatic loop
configuration), setting the default HP•ILaddress to be used when the
HP 5890 is connected to some device where addresses must be set
manually (i.e., no automatic loop configuration), switching the INET
function at the HP 5890 between global or local, and verifying INET
signal definitions. Each feature is discussed separately.
Figure 5-8
CONFIGURE NETWORK Displays
CONFIGURE
GLOBAL
LOCAL
ACTUAL SETPOINT
NETWORK
ACTUAL SETPOINT
ADDR: 8,31
ACTUAL SETPOINT
ADDR: 8,31
85