Table of Contents
Advertisement
Port PVRST configuration
Command: /cfg/port <port number>/stp
[Port 1 STP Menu]
The following table describes the port PVRST Configuration Menu options.
Table 103
Port PVRST Configuration Menu options
Command
edge enable|disable
link auto|p2p|shared
cur
edge
- Enable/disable edge port (for PVRST only)
link
- Set port link type (auto, p2p, or shared; default: auto)
(for PVRST only)
cur
- Display current port stp configuration
Description
Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as the
link is up. Configure server ports as edge ports (enabled). The default
value is enabled.
Defines the type of link connected to the port, as follows:
•
auto—Configures the port to detect the link type, and automatically
match its settings.
•
p2p—Configures the port for Point-To-Point protocol.
•
shared—Configures the port to connect to a shared medium (usually
a hub).
The default link type is auto.
Displays current port PVRST parameters.
Configuration Menu 134
Advertisement
Table of Contents
