Table of Contents
Advertisement
RIP Interface configuration
Command: /cfg/l3/rip/if <1-249>
[RIP Interface 1 Menu]
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off
by default.
NOTE:
Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration Menu options.
Table 140
RIP Interface Configuration Menu options
Command
version 1|2|both
supply disable|enable
listen disable|enable
poison disable|enable
split disable|enable
trigg disable|enable
mcast disable|enable
default
none|listen|supply|both
metric <1-15>
auth none|password
version
- Set RIP version
supply
- Enable/disable supplying route updates
listen
- Enable/disable listening to route updates
poison
- Enable/disable poisoned reverse
split
- Enable/disable split horizon
trigg
- Enable/disable triggered updates
mcast
- Enable/disable multicast updates
default
- Set default route action
metric
- Set metric
auth
- Set authentication type
key
- Set authentication key
enable
- Enable interface
disable
- Disable interface
current
- Display current RIP interface configuration
Description
Configures the RIP version used by this interface.
The default value is version 2.
When enabled, the switch supplies routes to other routers. This command is
enabled by default.
When enabled, the switch learns routes from other routers. This command
is enabled by default.
When enabled, the switch uses split horizon with poisoned reverse. When
disabled, the switch uses only split horizon. The default value is disabled.
Enables or disables split horizon. The default value is enabled.
Enables or disables Triggered Updates. Triggered Updates are used to
speed convergence. When enabled, Triggered Updates force a router to
send update messages immediately, even if it is not yet time for the update
message. The default value is enabled.
Enables or disables multicast updates of the routing table (using address
224.0.0.9). The default value is enabled.
When enabled, the switch accepts RIP default routes from other routers, but
gives them lower priority than configured default gateways. When
disabled, the switch rejects RIP default routes. The default value is
disabled.
Configures the route metric, which indicates the relative distance to the
destination. The default value is 1.
Configures the authentication type. The default is none.
Configuration Menu 166
Advertisement
Table of Contents
