Table of Contents
Advertisement
The following table describes the CIST parameters.
Table 24
Common Internal Spanning Tree parameter description
Parameter
CIST Root
CIST Regional Root
Priority (bridge)
MaxAge
FwdDel
Hops
Priority (port)
Cost
State
Role
Designated Bridge
Designated Port
Hello
Type
Description
Shows information about the root bridge for the Common Internal Spanning Tree
(CIST). Values on this row of information refer to the CIST root.
Shows information about the root bridge for this MSTP region. Values on this row
of information refer to the regional root.
The bridge priority parameter controls which bridge on the network will become the
STP root bridge.
The maximum age parameter specifies, in seconds, the maximum time the bridge
waits without receiving a configuration bridge protocol data unit before it
reconfigures the STP network.
The forward delay parameter specifies, in seconds, the amount of time that a
bridge port has to wait before it changes from learning state to forwarding state.
Shows the maximum number of bridge hops allowed before a packet is dropped.
The port priority parameter helps determine which bridge port becomes the
designated port. In a network topology that has multiple bridge ports connected to
a single segment, the port with the lowest port priority becomes the designated port
for the segment.
The port path cost parameter is used to help determine the designated port for a
segment. Generally speaking, the faster the port, the lower the path cost. A setting
of zero (0) indicates that the cost will be set to the appropriate default after the link
speed has been auto-negotiated.
Shows the current state of the port. The state field can be one of the following:
Discarding (DISC), Forwarding (FWD), or Disabled (DSB).
Shows the current role of this port in the Spanning Tree. The port role can be one of
the following: Designated (DESG), Root (ROOT), Alternate (ALTN), Backup (BKUP),
Master (MAST).
Shows information about the bridge connected to each port, if applicable.
Information includes the priority (hex) and MAC address of the Designated Bridge.
The port ID of the port on the Designated Bridge to which this port is connected.
Information includes the port priority (hex) and the port number (hex).
The hello time parameter specifies, in seconds, how often the root bridge transmits
a configuration bridge protocol data unit (BPDU). Any bridge that is not the root
bridge uses the root bridge hello value.
Type of link connected to the port, and whether the port is an edge port. Link type
values are AUTO, P2P, or SHARED.
Information Menu 47
Advertisement
Table of Contents
