Joint Cover Fl/Fr - Brother DCP-8070D Service Manual

9.18.4 Joint Cover FL/FR

(1) Turn the Joint cover upside down.
(2) Remove the two bind B M4x12 Taptite screws, and remove the Joint cover FL/FR.
Joint cover FR
Assembling Note:
• When assembling the Joint cover FL, Check that there is the USB PCB holder at
between the Joint cover and the Driver PCB holder as shown in the figure below.
Joint cover FL
USB PCB holder
Taptite bind B M4x12
Joint cover
Joint cover FL
Fig. 5-206
Fig. 5-207
5-177
Driver PCB holder
Driver PCB holder
Joint cover
Confidential