Scanner Unit Assy; Ccd Model - Brother DCP-8070D Service Manual

9.10 Scanner Unit ASSY

■ CCD model

Note:
• In the case of the
9.10.1 Scanner Unit ASSY
(1) Disconnect the connector of the Scanner motor harness from the Driver PCB.
(2) Disconnect the connector of the Home position sensor harness and FFC cable from the
Main PCB.
Note:
• After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
• When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cables are not at an angle.
Driver PCB
Scanner motor harness
FFC cable
Home position sensor harness
CIS model, refer to "9.10.9 Scanner Unit"
Main PCB
Fig. 5-148
.
5-132
Driver PCB
Main PCB
Confidential