Scanner Unit Assy - Brother DCP-8085DN Service Manual

9.46 Scanner Unit ASSY

(1) Disconnect the connector of the Scanner motor harness from the Driver PCB.
(2) Disconnect the connector of the Photo interrupter and FFC cable from the Main PCB.
Note:
• After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
• When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cables are not at an angle.
Driver PCB
Scanner motor harness
FFC cable
(3) Remove the two cup B M4x20 Taptite screws. Lift up the rear of the Scanner unit slightly
and remove the Scanner unit.
Taptite cup B M4x20
Photo interrupter
Main PCB
Fig. 5-96
Taptite cup B M4x20
3a
Hook
Fig. 5-97
Scanner unit
3b
5-82
Driver PCB
Main PCB
Hook
Confidential