3. USER-ACCESS TO THE MAINTENANCE MODE
Basically, the maintenance-mode functions listed on the
by service personnel only. However, you can allow end users to access some of these under
the guidance of service personnel (e.g., by telephone).
The user-accessible functions (codes 06, 09, 10, 11, 12, 25, 45, 53, 54, 80, 82, 87 and 88)
are shaded in the table given on the
switches, each of which has eight selectors. You should not allow end users to access all of
those selectors, but you can allow them to access user-accessible selectors which are
shaded in the firmware switch tables in
The service personnel should instruct end users to follow the procedure given below.
(1) Press the [Menu], [Start], [Menu], and [
The "MAINTENANCE 10" appears on the LCD.
(2) Press the [
code on the LCD.
Then press the [Menu] button.
(3) To switch the machine back to the standby state, press the [Stop/Exit] button. When
each of the user-accessible functions is completed, the machine automatically returns to
the standby state.
previous
APPENDIX
] button or [
] button several times to display the desired maintenance
previous page
page. Function code 10 accesses the firmware
1.
] buttons in this order.
7-3
should be accessed
Confidential