Brother DCP-8085DN Service Manual page 98

■ Error code 8A
Jam Tray 1
Remove the jammed paper from Tray 1.
Paper jam (Tray 1)
Error code 8B
Jam Tray 2
Remove the jammed paper from Tray 2.
Paper jam (Tray 2)
Error code 8C
Jam MP Tray
Remove the jammed paper from Multi Purpose Tray and press Start.
Paper jam (MP tray)
User Check
• Check if the paper is jammed in the appropriate tray. If jammed, remove it.
• Adjust the paper guide corresponding to the paper size.
• Check if too much paper is loaded in the tray.
Step
1 Dirt on edge sensor
Harness connection failure of
2 registration front sensor PCB
ASSY
Paper feeding kit worn out
3
(MP/ T1/ T2)
Registration front sensor PCB
failure (MP/ T1/T2)
4
5 Main PCB failure
Cause
3-26
Remedy
Clean the edge sensor.
Check the harness connection of the
registration front sensor PCB ASSY in the
appropriate tray, and reconnect it.
Replace the paper feeding kit of the
appropriate tray.
(MP/ T1) Check the sensor performance
following the procedure described in
"Maintenance mode 32". If any problem
occurs, replace the front door unit ASSY.
procedure described in
mode 32". If any problem occurs, replace
the LT paper feed frame unit.
Replace the main PCB ASSY.
"Maintenance
Confidential