Hitachi BD-W3300 Operating Instructions And Owner's Manual page 57

 You can change the wash, rinse, and spin cycle settings and use different combinations for 
operation.
(Setting changes cannot be saved.)
 You can save frequently used setting combinations by setting the [FAVORITE] program. 
 If water remains in the drum, run the spin cycle in the [FUZZY] program for 1 minute before operation.
If you start an operation with water already inside the drum (3 L or more), the wash load size may not be
detected, the detergent indicator may not display, and the [HOT WASH] function may not operate.
 Do not reuse laundry water.
Doing so may result in excessive foaming and malfunction.
 When only the [WASH] cycle is set, you can pause the operation, but you cannot add the [RINSE] or [SPIN]
cycles or change settings such as the wash time.
 When only the [SPIN] cycle is set, the remaining time display will be longer than the spin cycle time setting.
(This is because water drainage and correction of uneven distribution for the spin operation consume time.)
 You can perform partial operation of programs other than [FUZZY] by pressing the buttons for 
the cycles you do not want to use and turning off their indicators. (This is not possible in some
programs.) (P. 60)
pressing its
Set the
[HOT WASH]
function.
(When not
using this
function, skip
to )
 Do not use
the [HOT
WASH]
function when
starching
Press the
laundry.
[START]
button.
Cannot be
set
Resulting operation
The wash to spin cycles operate according to your
settings.
The laundry water is drained before operation stops.
The rinse water remains when the operation stops.
Washing and spinning is performed without rinsing.
Drainage and spinning is performed before the rinse, and
rinse water remains when the operation stops.
Drainage and spinning is performed before the rinse, and
spinning is performed again after rinse.
Drainage is performed before spinning.
(P. 54)
57