Hitachi BD-W3300 Operating Instructions And Owner's Manual page 92

Troubleshooting
Symptom
The remaining time
indicator blinks
and does not
decrease during
drying operations.
The remaining
time indicator
blinks after spin
operations.
The remaining
time indicator is
longer than the set
spinning time.
The remaining time
indicator displayed
immediately after
the operations
starts is longer
than the previous
time the operation
was used.
92
(continued)
Possible cause
 Operations may extend 1 to 2 hours after the
"10 minutes remaining" indicator appears.
This occurs automatically when the machine
detects that the laundry is not sufficiently dry.
Is the Tangle-Free Finish function set?
 This indicator display occurs during the
untangle process after spin operations.
Are you running the [SOFT] program?
 This indicator display occurs while warm air is
blowing onto laundry during spin operations.
 In addition to the actual operation time, the
remaining time indicator also includes the
time used for the correction of uneven laundry
distribution, the acceleration of the drum, etc.
 If the water pressure was low during the
previous operation (i.e., the water supply was
slow), the displayed time will be extended to
compensate for the longer water supply time.
 Is the water supply inlet's filter clogged?
Solution
This is not a malfunction.
The power turns off automatically when you press
the [PAUSE] button, allowing you to remove the
laundry.
For details on the Tangle-Free Finish setting, see
(P. 69).
This is not a malfunction.
This is not a malfunction.
This is not a malfunction.
Clean the water supply inlet. (P. 77)