Table of Contents
Advertisement
Symptom
Is the
When the inside of the drum is hot due to
drying operations and warm-air spinning,
a cooling operation is used to cool the
temperature down.
Is the CHILD LOCK set?
The CHILD LOCK will remain set and the
door will remain locked even when the power
automatically turns off after an operation
finishes.
The door does not
open.
Is there water inside the drum?
Depending on the water level during the
operation, the door lock may not release.
Is air blowing?
Even if you pause the operation, the door will
not open until the airflow stops.
Is "000" blinking in the remaining time
indicator?
If so, Soft Guard operation is in progress.
The [Door OPEN]
button is difficult
Depending on the operating environment, the
to press, and the
door bellows may stick to the door.
door does not
open easily.
Is there an obstruction stuck between the door
lock area?
The door does not
close.
Is the door stopper extended?
The drum and
Moisture and condensation from function tests
drain hose are wet,
even though they
performed at the factory may still remain in the
have never been
drum and drain hose.
used.
Contact with water and detergent can oxidize
The color of the
drum has changed.
and discolor the drum.
The power does
Is the power plug connected to a power outlet?
not turn on.
Did a power outage occur? Did a fuse blow or a
short circuit occur?
Is there an appliance that emits noise, such as
a television or radio, near the machine?
If noise continuously enters the machine, the
The operation
power will turn off.
stops or the power
turns off while in
If the temperature of the drum rotation
progress.
motor reaches a certain level, the power is
automatically turned off for safety.
If you start a drying operation while the dry
filter is clogged, the power may turn off
automatically.
Possible cause
indicator blinking?
HIGH
Solution
Wait until the inside of the drum cools down. You
can open the door when
HIGH
Release the CHILD LOCK.
(P. 33)
Run a spin operation to drain the water.
Wait until the airflow stops.
Press the [PAUSE] button to unlock the door. For
details on the Soft Guard setting, see
This is not a malfunction.
Press down on the [Door OPEN] button and pull
the door open while holding the area of the door
near the button (indented area).
Remove any objects.
Press the right middle area of the door, and close
it completely.
Return the door stopper to its original position.
(P. 33)
This is not a malfunction.
If this is a concern, wipe the drum using a
stainless steel detergent.
Connect the power plug to a power outlet.
Press the [ON] button, and restart the operation.
Disconnect the power plug and reconnect it,
and then press the [ON] button and restart the
operation. Do not place televisions and radios
near the machine.
This is not a malfunction.
Wait about 1 hour before restarting the operation.
This is not a malfunction.
Clean the dry filter.
(P. 73, 74)
turns off.
(P. 32)
(P.
69).
85
Hide quick links:
Advertisement
Chapters
Table of Contents
