Hitachi BD-W3300 Operating Instructions And Owner's Manual page 80

Indicator and meaning
Drying is not complete, even
after 6 hours of drying.
The door cannot be locked or
unlocked.
The lint filter is not inserted
properly.
The lint filter is clogged.
Spinning is not possible.
The drying load is too large.
The drum cannot rotate.
The dry filter is clogged.
If the following occurs, stop operations and contact a service representative.
 If the "CXX" indication persists even after performing the above solutions.
 If an "FXX" or "CXX" indication not described above persists even after turning the power off and turning it on
again.
80
 Check whether there is lint in dry filter or dry filter
port.
If it is clogged, perform maintenance.
 Make sure the laundry has been spun and is not
tangled.
 Make sure water is being properly supplied. (Water is
Press
used for cooling operations during drying.)
to turn off
Refer to the solution for when "C01" is displayed.
the power.
 Make sure the drain hose is installed properly.
Refer to the solution for when "C02" is displayed.
 This appears after every 25 times the [WASH DRY]
and [DRY] operations are used (even if lint buildup is
low).
 Close the door completely.
 Make sure the laundry load is not too large.
Press
to pause.
 Insert the lint filter properly.
Turn the lint filter knob clockwise until it clicks into
place.
 Check whether the lint filter is clogged.
Press
If it is clogged, perform maintenance.
to turn off
 This appears after the [WASH] and [WASH DRY]
the power.
operations are used (even if lint buildup is low).
 Make sure the drain hose is installed properly.
Refer to the solution for when "C02" is displayed.
(P. 79)
Press
 Check whether there is excessive foaming.
to pause.
Run a rinse operation before trying to spin again.
(P. 55)
 Check the size of your laundry load.
Reduce the number of items.
Press
The amount of laundry that can be dried depends
to pause.
on the size and type of the items.
 Check the size of your laundry load.
Reduce the number of items.
 Check whether the laundry is tangled.
Untangle the laundry.
 Check whether there is excessive foaming.
Press
Run a rinse operation before trying to spin again.
to pause.
(P. 55)
 Do not use an extension cord to connect the power
plug.
 Do not connect other appliances to the same power
outlet as the machine.
 Check whether there is lint in dry filter or dry filter
port.
If it is clogged, perform maintenance.
(The [DRY FILTER] indicator may light again, even
Press to
after you clean the dry filter and turn the power on.
turn off the
In such cases, press [START] to turn it off.)
power.
 This appears after every 25 times the [WASH DRY]
and [DRY] operations are used (even if lint buildup is
low).
Possible cause and solution
(P. 71, 72)
(P. 73, 74)
Press
to start the
operation.
Press
to start the
operation.
Press
to start the
operation.
Press
(P. 71, 72)
to start the
operation.
Press
to start the
operation.
Press
to start the
operation.
Press
to start the
operation.
(P. 73, 74)
Press
to start the
operation.