Option Configuration; Figure 97: Internet Connection Setup Wizard - D-Link DWC-1000 User Manual

Wireless Controller

Figure 97: Internet Connection Setup Wizard

You can start using the Wizard by logging in with the administrator password for the
controller. Once authenticated set the time zone that you are located in, and then choose
the type of internet connection type: DHCP, Static, PPPoE, PPTP, L2TP. Depending on
the connection type a username/password may be required to register this controller
with the ISP. In most cases the default settings can be used if the ISP did not specify
that parameter. The last step in the Wizard is to click the Connect button, which
confirms the settings by establishing a link with the ISP. Once connected, you can move
on and configure other features in this controller.
6.2

Option Configuration

Setup > Internet Settings > Option1 Settings > Option1 Setup
You must either allow the controller to detect Option connection type automatically or
configure manually the following basic settings to enable Internet connectivity:
Connection type: Based on the ISP you have selected for the primary Option link for this
controller, choose Static IP address, DHCP client, Point-to-Point Tunneling Protocol
(PPTP), Point-to-Point Protocol over Ethernet (PPPoE), Layer 2 Tunneling Protocol
173
User Manual