Configuring Ipv6 Router Advertisements - D-Link DWC-1000 User Manual

Wireless Controller
IAs with clients. DHCP clients use DUIDs to identify a server in messages where a
server needs to be identified.
IAID: An identifier for an IA, chosen by the client. Each IA has an IAID, which is
chosen to be unique among all IAIDs for IAs belonging to that client.: This is the
DHCP server IP address.

2.1.6 Configuring IPv6 Router Advertisements

Router Advertisements are analogous to IPv4 DHCP assignments for LAN clients, in
that the router will assign an IP address and supporting network information to devices
that are configured to accept such details. Router Advertisement is required in an IPv6
network is required for stateless auto configuration of the IPv6 LAN. By configuring
the Router Advertisement Daemon on this router, the DWC-1000 will listen on the
LAN for router solicitations and respond to these LAN hosts with router advisements.
RADVD
Advanced > IPv6 > IPv6 LAN > Router Advertisement
To support stateless IPv6 auto configuration on the LAN, set the RADVD status to
Enable. The following settings are used to configure RADVD:
RADVD Status: You can enable the RADVD process here to allow sta teless auto
configuration of the IPv6 LAN network.
Advertise Mode: Select Unsolicited Multicast to send router advertisements
(RA's) to all interfaces in the multicast group. To restrict RA's to well-known
IPv6 addresses on the LAN, and thereby reduce overall network traffic, select
Unicast only.
Advertise Interval: When advertisements are unsolicited multicast packets, this
interval sets the maximum time between advertisements from the interface. The
actual duration between advertisements is a random value between one third of
this field and this field. The default is 30 seconds.
RA Flags: The router advertisements (RA's) can be sent with one or both of these
flags. Chose Managed to use the administered /s tateful protocol for address auto
configuration. If the Other flag is selected the host uses administered/stateful
protocol for non-address auto configuration.
27
User Manual