Feeder (DADF-P1)
You should use the feeder when you want to scan several originals at the same
time. Place the originals into the feeder and press [Start]. The machine
automatically feeds the originals to the scanning area and scans them into memory.
In addition, if you set the Two-Sided Original mode, the both sides of a two-sided
original can be scanned without the need for turning over the sheet manually.
You can place the following originals into the feeder's original supply tray:
•
Weight:
- 14 lb bond to 28 lb bond [52 g/m
bond to 14 lb bond [37 g/m
2
128 g/m
])
•
Size:
- 11" × 17", LGL, LTR, LTRR, STMT
•
Tray Capacity:
- LTR/LTRR: 50 sheets (20 lb bond [80 g/m
- LGL/11" × 17": 25 sheets (20 lb bond [80 g/m
IMPORTANT
•
Do not place the following types of originals into the feeder:
- Originals with tears or large binding holes
- Severely curled originals or originals with sharp folds
- Clipped or stapled originals
- Carbon backed paper or other originals which may not feed smoothly
- Transparencies and other highly transparent originals
•
If the same original is fed through the feeder repeatedly, the original may fold or become
creased, and make feeding impossible. Limit repeated feeding to a maximum of 30 times
(this number varies, depending on the type and quality of the original).
•
If the feeder rollers are dirty from scanning originals written in pencil, perform the feeder
cleaning procedure. (See Chapter 7, "Routine Maintenance," in the Reference Guide.)
•
Always smooth out any folds in your originals before placing them into the feeder.
•
Place the originals one by one if they are very thin (10 lb bond to 14 lb bond (37 g/m
2
51 g/m
)) or very thick (28 lb bond to 32 lb bond(105 g/m
2
to 105 g/m
2
] (One-page scanning for 10 lb
2
2
to 52 g/m
] and 28 lb bond to 32 lb bond [105 g/m
2
])
2
])
2
2
to 128 g/m
)).
Placing Originals
1
2
to
2
to
1-39