Components Removed From The Rear Of The Range; Removing Rear Manifold Cover; Removing Back Cover; Removing Heat Shield - Electrolux Next Gen 30" Service Manual

Disconnecting tubing at rear of safety valve
3. Remove storage drawer and disconnect the wires
from the safety valve.
4. Using a 9/16" wrench disconnect the gas tubing at
the valve from the pressure regulator.
Disconnecting tubing inside at safety valve
5. Remove the four screws holding the safety
valve to the rear liner.
Four screws

Removing rear manifold cover:

1. Remove one screw holding the cover to the bodyside
and swing the cover out.
One screw and two tabs

Removing back cover:

1. Disconnect electrical power from the range.
2. Remove rear manifold cover.
3. Remove one screw from each end of the panel.
Back cover screws
Removing the heat shield:
1. Disconnect electrical power from the range and
remove rear cover.
2. Disconnect the wires from the oven light and oven
sensor.
3. Remove the three screws holding the heat shield to
the oven back.
107