Control Will Not Program; Blank Display; No Heat - Electrolux Next Gen 30" Service Manual

RTD
Temperature (°F)
32 ± 1.9
75 ± 2.5
250 ± 4.4
350 ± 5.4
450 ± 6.9
550 ± 8.2
650 ± 9.6
900 ± 13.6

Control will not program:

If the control will not program check for an open sensor
circuit. If the sensor circuit is good replace the control.

Blank Display:

If the display on the oven control is blank, with the
range connected to electrical power:
1. Go to the back of the control and measure the
voltage drop between pins 5 and 4 of the 6 pin plug.
If the meter reads line to neutral voltage (120 VAC)
the control is defective. If the meter reads zero the
wiring in the range is defective.

No heat:

If the control appears to be operating normally,
but the oven does not heat in bake or broil:
1. Program the control for bake and check to see if
the oven igniter is glowing. If the igniter is not glowing
go to step 2. If the igniter is glowing check the
manual gas shut-off for the oven to be sure gas is
being supply to the safety valve. Then remove the
igniter, connect it to 120 VAC and measure the
current flow through the igniter. If the current flow is
less than 3.2 amps replace the igniter. If the current
flow is 3.2 or more check the wiring in the oven
circuit for a poor connection.
2 Go to the back of the oven control, disconnect the
six pin plug and measure the voltage drop between
pins 5 and 6. If the meter reads 120 VAC the control
is defective. If the meter reads zero the igniter, safety
valve or the wiring in the oven circuit is open. Go to
step 3.
3. Disconnect power to the range, disconnect the wires
from the igniter and check it for continuity with an
Ohmmeter. If the meter reads open replace the
igniter. If the meter shows continuity check the
SCALE
Resistance (ohms)
1000 ± 4.0
1091 ± 5.3
1453 ± 8.9
1654 ± 10.8
1852 ± 13.5
2047 ± 15.8
2237 ± 18.5
2697 ± 24.4
continuity of the safety valve. If the meter reads
open replace the safety valve. If the meter show
continuity one of the wires in the oven circuit is open.
If the control appears to be operating normally,
and the oven heats in bake but not in broil, or the
oven heats in broil but not bake, replace the control.
42