Removing Pressure Regulator; Removing Top Burner Igniter Spark Module; Removing Lock Motor Assembly - Electrolux Next Gen 30" Service Manual

Three screws
Removing the pressure regulator:
1. Disconnect electrical power and turn off the gas to
the range.
2. Using a 9/16" wrench disconnect the tubing at from
the pressure regulator.
3. Remove the two screws holding the bracket to the
back of the range and lift the regulator off.
Two bracket screws
4. Remove the three screws holding the pressure
regulator to the bracket.
Three screws
Removing top burner spark module:
1. Disconnect electrical power from the range and
remove rear cover.
2. Disconnect the wire from the spark module.
3. The spark module is held to the bodyside by two
tabs. To release the spark module push up on the
bottom tab with a screw driver.
Push up on tab
4. To reinstall snap the module back into bodyside.

Removing lock motor assembly:

1. Disconnect electrical power from the range and
remove rear cover.
2. Disconnect and mark the wires from lock motor
assembly.
3. Remove the three screws holding lock assembly to
the back of the range.
Lock motor assembly mounting screws
108