Removing Bodyside Panels - Electrolux Next Gen 30" Service Manual

Tennamen nut

Removing bodyside panels:

1. Disconnect power and remove the back of the control
panel and the back cover.
2. Place a rug or padding under the range to protect
the floor.
3. Remove the backguard end cap on the side of the
range that the bodyside is being removed.
4. Remove the oven door and drawer.
6. Remove five screws holding the bodyside panel to
the back of the range.
Bodyside back screws
6. Remove one screw in the back holding the
bodyside panel to bottom rail.
7. Remove five screws from the front. It is not necessary
to remove the two short screws holding the heat
shield in the upper corner, but you do need to transfer
this to the replacement panel if the panel is being
replaced.
Bodyside bottom rail screw
Bodyside front screws
8. Remove the top locating pin and the two screws
holding the bodyside to the burner pan.
Bodyside top screws and pin
9. With one hand in the oven and the other in the back
lift the side of the range with the bodyside you are
removing. Slide the bodyside down and the bottom
of the panel out.
110