Oven Door Locks When The Oven Is Programmed For Clean But The Oven Does Not Heat; Lock Motor Runs Continuously; Door Latch Is Partly Closed With Door Open - Electrolux Next Gen 30" Service Manual

the resistance between pins 5 and 6 in the 15 pin
plug (in the plug). If the meter reads infinity the lock
motor or the wiring to the lock motor is defective. If
the meter reads around 1500 ohms go to step 2.
2. Measure the resistance between pins 10 and 12 of
the 15 pin plug with the oven door closed. If the
meter reads infinity the door switch or the wiring to
the door light switch is defective. If the meter reads
zero go to step 3.
3. Measure the resistance between pins 11 and 12 in
the 15 pin plug. If the meter reads infinity the lock
switch or the wiring to the lock switch is defective. If
the meter reads zero the control is defective.
Oven door locks when the oven is programmed for clean
but the oven does not heat:
1. If the oven operates in normal bake replace the
control.

Lock motor runs continuously:

1 With the door in the unlock position, remove power
from the range. Go to the back of the control and
disconnect the 15 pin plug from the control. With an
Ohmmeter measure the resistance between pins 10
and 11 in the 15 pin plug. If the meter reads zero the
lock switch or the wiring to the lock switch is
defective. If the meter reads infinity go to step 2.
2, Depress the arm of the lock switch, and measure
the resistance between pins 10 and 11 in the 15 pin
plug. If the meter reads infinity the lock switch or
the wiring to the lock switch is defective. If the meter
reads zero the control is defective.
Door latch is partly closed with door open, cannot close
door:
1. Program the oven for self-clean, and hold in on the
door switch for 30 seconds. Touch cancel and hold
door switch in for 30 seconds. The lock motor should
lock and unlock the door.
83