Control Panel Assembly; Removing The Control Panel - Dell DL4000 Owner's Manual

7. Close the system.
8. Reconnect the system to its electrical outlet and turn the system on, including any attached
peripherals.
9. If applicable, install the front bezel.

Control panel assembly

Removing the control panel

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. If installed, remove the front bezel.
2. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
3. Open the system.
4. Using a #1 Philips screwdriver, remove the screw (located at the bottom of the chassis) that secures
the control panel to the chassis.
5. Remove the control panel cable from the connectors on the system board (J_CP and J_FP_USB) and
the hard-drive expander card.
NOTE: To locate the connectors on the system board, see System Board Connectors.
6. Press the control panel latch and slide the control panel out of the chassis.
7. Disconnect the control panel cable from the control panel.
61