Installing The Control Panel - Dell DL4000 Owner's Manual

Figure 29. Removing and installing the control panel
1. control panel release latch
2. J_CP connector on system board
3. control panel cable connecting to system board
4. J_FP_USB connector on system board
5. cable securing clip
6. screw
7. control panel

Installing the control panel

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Route the control panel cable through the chassis and connect the control panel cable to the
control panel.
2. Push the control panel into the chassis till it snaps into place.
3. Using a #1 Philips screwdriver, replace the screw (located at the bottom of the chassis) that secures
the control panel to the chassis.
4. Locate the connectors J_CP and J_FP_USB on the system board.
62